> Compresseurs - Limiteurs - Gates

Compresseurs - Limiteurs - Gates  Il y a 71 produits.

  • Afficher :
par page
  • Charter Oak - SCL-1

    FREQUENCY RESPONSE 20Hz-22kHz HARMONIC DISTORTION Less then 1% with 20dB of gain reduction @ +20dBm output. MAXIMUM OUTPUT +22 dBm SIGNAL TO NOISE RATIO -85dB referenced to +10dBm ATTACK TIME Adjustable from 100us to 5ms HOLD TIME Less than 2ms. Unit provides a soft clip. (Less than 3% total harmonic distortion @ 3dB clip) RELEASE TIME Adjustable from...

    2 597 €HTVA
  • Crane Song - STC-8

    Compressor Attack Time: FAST; measured by doing 18 dB of Gain Reduction. The time to 18 dB of Gain Reduction is less than 1mS. 12 dB of the 18 are reached in .4mS. SLOW; for 6 dB of GainReduction, 100mS Compressor Release Time: FAST; From 12 dB of Gain Reduction to No Gain Reduction. 11 of 12 dB are reached in 50mS (Non Program Dependant Release) SLOW; 20...

    0 €HTVA
  • Crane Song - Trakker

    Input: Floating, balanced. Maximum input is +25 dBm. The connectors are XLR. Output: Floating, balanced. Maximum output is +25 dBm. The connectors are XLR. For Input and Output : Pin 2 is Sig + , Pin 3 is Sig – , Pin 1 is GND Side Chain Connections: Floating, balanced. Connections are made by using a DB-9 Male Connector. This is a loop insert and must be...

    0 €HTVA
  • DAKING - FET II

    MeterVU Movement for GainReduction-Input-OutputThreshold-10dbu to +10dbuRatio1.5:1 to 20:1Attack250uS to 64 MSReleaseSingle Time Constant.5Sec,1 Sec, 1.5 SecDual Time Constant33609 Auto, Compex AutoTriple Time ConstantFairchild 670#'s 5&6

  • DAKING - FET III

    Method of Limiting: FET (Field Effect Transistor) used as a variable resistorStereo Linking Method: Continuously Variable Audio SummingPower: 48volts dc @ 150 maOutput Drive: Differentially balanced +24dbv @ 1kHz 600 ΩRatios: 1.5:1, 2:1, 3:1, 5:1, 10:1, 20:1Attack Times: 250 μs to 64 msRelease Times: 500 ms to Auto Dual Time ConstantFrequency Response:...

  • Dangerous Music - Compressor

    Frequency Response: +/-0.25dB from 15Hz to 80kHz Maximum level: > +27dBu Noise floor: < -93dBu band limited from 22Hz-22kHz THD+N: < 0.005% IMD: < 0.007% Crosstalk rejection: > 115dB @1kHz Input Impedance: 20K Ohms Output Impedance: 50 Ohms Replacement Fuses: USA 500mA fast blow for 120V Europe 250mA...

  • DBX - 160A

    Features OverEasy® or classic hard knee compression with dbx's® ultra-musical program dependent attack and release times Compression ratio variable from 1:1 through infinity :1 to negative compression Precision dual RMS LED display monitors input or output and gain reduction over a wide range and calibrates for different operating levels Over 60dB of gain...

  • DRAWMER - 1968

    INPUT IMPEDANCEInput Impedance 20k Ohms Maximum Input Level +20dBuOUTPUTOutput Impedance 50 Ohms Maximum Output Level +21dBuBANDWIDTH < 17Hz to 28kHz -1dB < 10Hz to 47kHz -3dBUNITY GAIN NOISE 22Hz - 22kHz (RMS) -85dBCROSSTALK better than 70dB @ 10kHz better than 100dB @ 1kHzDISTORTION (THD & Noise) 1kHzLine Input with BYPASS selected <...

  • DRAWMER - 1973

    Features Standard intuitive controls such as Threshold, Gain, Switched Attack & Release with Gain Reduction Metering on Each Band. Fast Reacting Soft Knee F.E.T. Design with excellent Left/Right Tracking across the Full Range of compression. Variable Wet/Dry Mix plus Output Gain Knobs give a 'Parallel Compression' function without the need for...

  • DRAWMER - 1968

    INPUT Input Impedance 20k Ohms or greaterMaximum Input Level +21dBu OUTPUT Output Impedance < 100 Ohms Maximum Output Level +21dBu into 10k Ohms Load FREQUENCY RESPONSE 20Hz to 20kHz +/-0.2dB CROSSTALK < -70dB @ 1kHz NOISE AT UNITY GAIN with flat EQ response switched in circuit 22Hz - 22kHz -88dB % DISTORTION (THD & NOISE) @ 1kHz 0dB (ref +4)...

  • DRAWMER - DL241

    INPUT IMPEDANCE 20KOhm MAXIMUM INPUT LEVEL +20dBu OUTPUT IMPEDANCE 50 Ohm (bal), 100 Ohm (unbal) MAXIMUM OUTPUT LEVEL +20dBu BANDWIDTH < 10Hz to 22KHz -1dB NOISE AT UNITY GAIN with Expander Off Wideband 22Hz - 22KHz CCIR ARM IEC A Q-Pk CCIR AV -90dB -95dB -95dB -97dB -84dB RMS -88dB -93dB -93dB -95dB -82dB Distortion 100Hz 1KHz 10KHz Unity Gain,...

    0 €HTVA
  • DRAWMER - DL251

    Input impedance20KOhm Maximum input level+21dBu (+17dB ref. +4dBu) Output impedance50 Ohm Maximum output level±20dBu Bandwidth< 12Hz to 25KHz - 1dB Crosstalk@10kHz Better than -80dB@20kHz Better than -70dB Noise at unity gain reference +4dBu Wideband22Hz - 22KHzCCIR ARMIEC AQ-Pk...

Résultats 13 - 24 sur 71.